Numerical Analysis of the Aerodynamic Contribution of the Front Wing, Rear Wing, and Diffuser on a Formula 1 Car: A Full versus Stripped Configuration Study
DOI:
https://doi.org/10.58445/vvpjdm36Keywords:
Computational Fluid Dynamics, Formula One, aerodynamics, Drag Coefficient, Downforce, ANSYS Discovery, Computer-Aided DesignAbstract
This study aims to see whether the presence of major aerodynamic components affects the drag coefficient and downforce of a Formula 1 car by comparing a full cart model against a stripped-down model without the aerodynamic components. Simulations were conducted in ANSYS Discovery 2026 R1 at inlet velocities of 50, 100, and 200 mph to accurately represent the speeds Formula 1 cars reach. The simulations reproduced the expected quadratic relationship between force and velocity to within approximately eight percent across a fourfold change in speed, confirming that the solver captured fundamental aerodynamic behavior. However, the difference in aerodynamic coefficients between the two configurations was small, ranging from roughly two to eight percent, which falls within the estimated uncertainty of the simulation method. The study therefore reports a null result: under the meshing fidelity available in Explore mode, the aerodynamic contribution of the removed components could not be resolved. This outcome is interpreted not as evidence that these components are aerodynamically unimportant, since the established literature demonstrates otherwise, but as an indication of the resolution limits of GPU-based exploratory computational fluid dynamics (CFD).
References
[1] Bhatnagar, Unmukt R. Formula 1 Race Car Performance Improvement by Optimization of the Aerodynamic Relationship Between the Front and Rear Wings. 2014. Pennsylvania State University, Master's thesis. https://etda.libraries.psu.edu/catalog/23699.
[2] Castro, Xabier, and Zeeshan A. Rana. "Aerodynamic and Structural Design of a 2022 Formula One Front Wing Assembly." Fluids, vol. 5, no. 4, 2020, article 237. https://doi.org/10.3390/fluids5040237.
[3] Om Raj, R. R., et al. "Design and CFD Analysis of a Rear Wing of a Motorsport Car." International Journal of Vehicle Structures and Systems, vol. 14, no. 1, 2022. https://doi.org/10.4273/ijvss.14.1.14.
[4] Ravelli, Umberto, and Marco Savini. "Aerodynamic Simulation of a 2017 F1 Car with Open-Source CFD Code." Journal of Traffic and Transportation Engineering, vol. 6, no. 4, 2018, pp. 155-63. https://www.davidpublisher.com/index.php/Home/Article/index?id=36717.html.
Downloads
Posted
Categories
License
Copyright (c) 2026 Research Archive of Rising Scholars

This work is licensed under a Creative Commons Attribution 4.0 International License.